Enhanced TDS
Identification & Functionality
- Chemical Family
- Product Type
- Technologies
- Product Families
- Product Information
Technology / Base Two-component Methylmethacrylate (MMA) Type of Product MMA Curing Mechanism Polymerization Appearance / Color White Consistency Liquid
Features & Benefits
- Labeling Claims
- Ready-to-Use Product Features
- Key Attributes
- Permanent unitizing structural adhesive
- Matches white PVC trim boards
- Paintable, sandable
- Fills nail holes and gaps
- Meets 2009 EPA VOC & CARB requirements
- Product Highlights
- PVC TrimWelder™ Fast Cure adhesive does not require special surface preparation and does not contain any solvents.
- It will work successfully in most applications without preparation.
- It is so strong that it appears to weld the PVC together.
- This adhesive has a creamy consistency that will not foam, run or drip.
- PVC TrimWelder™ Fast Cure is a fast curing, two-component product with an open time of 4 - 7 minutes at 73°F after thorough mixing with approved mix tips.
- It will cure satisfactorily at application temperatures as low as 20°F.
Applications & Uses
- Markets
- Applications
- Application Area
- Compatible Substrates & Surfaces
- Typical Applications
Combine resin and activator in equal volume and mix thoroughly. For convenience and accuracy use pre-measured cartridges with disposable static mixers. Open time is 4 - 7 minutes at room temperature. Handling strength within approximately 10 - 30 minutes.
Properties
- Color
- Physical Form
- Cured Properties
- Uncured Properties
| Value | Units | Test Method / Conditions | |
| Impact Resistance (on steel) | 20 | ft.lbs/in² | - |
| Lap Shear Strength (as rec'd CRS) | 2340 | psi | - |
| Hardness | 75.0 | - | Shore D |
| Adhesive Testing (on plastics, PVC, ABS glass filled nylon, stirene) | Substrate failure | - | - |
| Thermal Service Range | -65 - 260 | °F | - |
| Chemical Resistance | Excellent | - | - |
| Elongation | 60.0 | % | - |
| Peel Strength (on Aluminum) | 20 - 25 | psi | - |
| Lap Shear Strength (Aluminum) | 3390.0 | psi | - |
| Lap Shear Strength (Grit blasted steel) | 3365 | psi | - |
| Typical Film Thickness | 0.03 | inches | - |
| Value | Units | Test Method / Conditions | |
| Viscosity (Mixed, at 25°C) | 50000 | cPs | - |
| Flash Point | 51.0 | °F | Cleveland open cup |
| Toxicity | Moderate | - | - |
| Solvents | None | - | - |
| Mix Ratio | 1 : 1 | - | - |
| Fillers | Yes | - | - |
| Specific Gravity (at 20/20°C) | 1.01 | - | - |
| Clean Up Solvents | MEK, Acetone | - | - |
Packaging & Availability
- Country Availability
- Packaging Type
- Regional Availability
- Packaging Information
Side-by-side cartridges.
Storage & Handling
- Shelf Life
- 12 Months
- Storage & Shelf Life
Store in an unopened original container in a cool, dark area between 55°F to 75°F. Shelf Life is 12 months