Enhanced TDS
Identification & Functionality
- Chemical Family
- RTU Product Type
- Technologies
- Product Families
Features & Benefits
- Labeling Claims
- Ready-to-Use Product Features
- Features & Benefits
- No solvents, plasticizers, or low volatile components
- Fast curing
- 1:1 mix ratio by volume, designed for easy use with automated dispense systems
- Excellent moisture penetration seal
- Extreme environmental and abrasion resistance
- Room temperature curing, no heat required
- Non-conductive, non-corrosive
- Outstanding chemical resistance
- High impact strength
- Will not induce stress cracking in polycarbonate or polyethylene parts
Applications & Uses
- Markets
- Applications
- Compatible Substrates & Surfaces
- General Instructions
Surfaces to be bonded must be clean, dry and free from grease, oil, wax, weak oxide films and other contaminants. Bring both components to room temperature prior to mixing. Measure out specified amounts of parts A and B and mix, without introducing bubbles, until homogenous. Meter-mix equipment equipped with an automatic purge is recommended for higher volume applications. Contact your H.B. Fuller representative for suggested application equipment to suit your specific needs. We recommend that containers be purged with nitrogen after they are opened to the air and not all the material is used.
Properties
- Color (Properties)
- Physical Form
- Component A
Value Units Test Method / Conditions Viscosity 90000 cPs - - Typical Properties
Value Units Test Method / Conditions Storage Temperature 16 - 25 °C - - Component B
Value Units Test Method / Conditions Viscosity 5000 cPs - - Cured Properties
Value Units Test Method / Conditions Elongation at Break (at 25°C, 50% RH) 57 % ASTM D638 Overlap Shear Strength (at 25°C, 50% RH, aluminum, abraded) 2760 psi ASTM D1002 Overlap Shear Strength (at 50% RH, E-Coat steel, IPA wipe) 20.05 MPa ASTM D1002 Overlap Shear Strength (at 50% RH, nylon 6-6, abraded) 5.8 MPa ASTM D1002 Hardness 80 Shore D ASTM D2240 Overlap Shear Strength (at 50% RH, stainless steel, abraded cured) 14.9 MPa ASTM D1002 Tensile Strength (at 25°C, 50% RH) 13.9 MPa ASTM D638 - Uncured Properties
Value Units Test Method / Conditions Mix Ratio (by volume) 1:1 - - Full Cure (at 23°C, full uncured) 2 - 3 days - Specific Gravity 1.25 - - Full Cure (at 70°C, full uncured) 1 - 2 hours - Gel Time (at 23°C, 100g) 4 minutes - Mix Ratio (by weight) 100:84 - -
Packaging & Availability
- Regional Availability
Storage & Handling
- Shelf Life
- 12 months
- Storage
Product should be stored in a cool dry place out of direct sunlight. The shelf life is from date of manufacture. Shelf life is based on the products being stored properly at temperatures between 16°C and 25°C. Exposure to temperatures above 25°C will reduce the shelf life. This product should not be frozen. Purge opened containers with dry nitrogen inert blanketing gas before resealing.