Enhanced TDS
Identification & Functionality
Features & Benefits
- Ready-to-Use Product Features
- General Properties
Product Benefits
- Resistant to various chemicals, such as petrol, oils, greases
- Excellent static and dynamic fatigue resistance
- Excellent adherence to various substrates
- Easy application
- Minimal mould fouling
- Excellent pre-bake resistance
- Excellent low temperature resistance
- Good heat resistance
- Good boiling water resistance
- Very good salt spray resistance
Type of Product
- Bonding agent
- Used as a primer for other Cilbond grades
Curing
- Heat curing
Colour
- Grey
Applications & Uses
- Markets
- Applications
- Application Area
- Application Method
- Compatible Substrates & Surfaces
- Cure Method
- Segment
- Cleaning Information
- Cleaner for Tools : Methyl ethyl ketone (MEK)
- Clean tools immediately after use. Once cured, the material can only be removed mechanically.
- Processing Information
Suitable Elastomers
- Natural rubber (NR)
- Styrene butadiene rubber (SBR)
- Chloroprene Rubber (CR)
- Polybutadiene (BR)
- Synthetic polyisoprene rubber (IR)
- Polyepichlorohydrin (ECO)
- Polyacrylate rubbers (ACM)
- Chlorosulphonated polyethylene (CSM / ACSM)
- Carboxylated NBR (XNBR)
- Ethylene vinyl acetate EVA (EVM)
- HNBR
- IIR
- EPDM
- Millable polyurethane (PU)
- Chlorinate polyethylene (CPE)
- Halogenated butyl rubber (CIIR or BIIR)
- NBR
Suitable Substrates
- Various surface treated metals
- Glass fibre reinforced plastic (GFRP)
- Various metals Polyamide (PA)
- Polyester (PES)
- Thermosetting plastics
- Various other substrates
Surface Requirements
- Free of rust
- Grit blasted or other approved surface treatments
- Dry
- Clean
- Free of grease
- Free of dust
- Free of oil
Application Method
- Spraying
- Dipping
- Roller coating
- Brushing
Properties
- Physical Form
- Appearance
- Grey liquid
- Physical Properties
Value Units Test Method / Conditions Density 0.94 g/cm³ Solid Content 27 Wt(%) - Flash Point 14 °C Abel Pensky Method - Processing Parameters
Value Units Test Method / Conditions Storage Temperature 5 - 30 °C Dilution (typically, add whilst product is stirring) 5 - 30 % - Moulding Temperature Range 130 - 220 °C Typical Coverage (at 15 μm dry coating thickness) 20 m²/L - Optimum Dry Coating Thickness 10 - 15 µm Service Temperature -50 to 200 °C Viscosity (at 26°C) 16 seconds No 3 Zahn Cup Drying Time (at 25°C) 30 - 45 minutes Drying Time (at 60°C) 5 - 15 minutes
Packaging & Availability
- Regional Availability
Storage & Handling
- Shelf Life
- 12 months
- Storage Conditions
Cilbond® 11 should be used within the shelf life specified on the packaging. The storage stability applies to material stored under appropriate conditions only (original unopened containers, recommended storage temperature).