Enhanced TDS
Identification & Functionality
- Chemical Family
- Product Type
- Technologies
- Product Families
Features & Benefits
- Ready-to-Use Product Features
Applications & Uses
- Markets
- Applications
- Application Area
- Application Method
- Compatible Substrates & Surfaces
- Guidelines for Use
Preparation:
- This product contains diisocyanates. Adequate training is required before industrial or professional use of this product.
- Use in a well Ventilated Area
- Check that the area to be bonded is dry, clean and free from water.
- Do not use if rain is imminent.
- Connect the braided hose to the canister and the spray gun to the hose and tighten the connections. Open the valve of the canister. If there are any leaks, tighten the connection at the source of the leak.
- The valve should remain open until the canister is used up. Use the locking nut on the gun after use. Turning off the valve will result in the adhesive drying in the hose and gun causing blockages.
Application:
- Apply 20-40mm wide beads of adhesive at 200mm intervals for roof perimeters and critical areas, 300mm centres for normal roof exposures or in compliance with specific wind uplift calculations as required. A larger degree of coverage may be needed for bonding wool insulation.
- Introduce the insulation boards directly onto the wet adhesive, applying even pressure across the piece to ensure contact between the substrates.
- Avoid walking over insulation boards for the first 15-30 minutes.
Properties
- Physical Form
- Appearance
- Straw - like
- Typical Properties
Value Units Test Method / Conditions Application Temperature 5 - 25 °C - Temperature Resistant 120.0 °C - Cure Time 24.0 hours - Cure Time 30.0 minutes - Cure Time 15.0 minutes - Cure Time 8.0 minutes - Coverage 350.0 m² - Solids Content 100.0 % - Storage Temperature 15 - 35 °C -
Packaging & Availability
- Packaging Size
Available Sizes:
22L Canister
Storage & Handling
- Shelf Life
- 12 months
- Disposal Information
- Once the canister is empty of any hazardous materials and depressurised, it can be considered as scrap metal, in accordance with the national or local waste company, under code EWC 15 01 04* (empty aerosol, non-hazardous residues).
- Canisters and aerosols that are still pressurised and contain product should be disposed of in accordance with the national or local waste company under code EWC 16 05 04* (full or partially empty aerosol).
- Storage & Shelf Life
- Protect from extremes of temperature in a controlled environment between 15 and 35°C, and away from direct sunlight. Do not stand on a cold concrete floor. Low temperatures can result in irreparable separation of the adhesive.
- Stored under the correct conditions, in original, unopened containers, the product will have a shelf life of 12 months. The adhesive will have a limited life once the container is opened.