Enhanced TDS
Identification & Functionality
- Polymer Name
- Product Type
- Technologies
Features & Benefits
Applications & Uses
- Markets
- Application Area
- Plastics & Elastomers End Uses
- Typical Applications
PHOTOCAP® 15585P is typically used in crystalline silicon modules where the cells are responsive below 360 nm. Due to the increase transmission of UV light, it is recommended that PHOTOCAP® 15580P be used behind the cells for backsheet protection.
- Lamination Instructions
- Platen temperature: 140 - 150°C
- Evacuation Time: 180 - 300 seconds
- Cure Time: 300 - 360 seconds
Properties
- Physical Form
- Typical Properties
Value | Units | Test Method / Conditions | |
Tensile Strength | 15.0 | MPa | ASTM D638 |
Shrinkage (Transverse direction) | max. 1 | % | IEC 62788 |
Ultimate Elongation | 530.0 | % | ASTM D638 |
Shrinkage (Machine direction) | max. 3 | % | IEC 62788 |
Adhesion (Glass) | 120.0 | N/cm | HBF |
Adhesion (Backsheet) | 60.0 | N/cm | HBF |
Moisture Vapor Transmission Rate | max. 25 | g/m²/24 hrs | AFTM F1249 |
Water Absorption | max. 0.5 | wt.% | ASTM D570 |
Optical Transmission | 92.0 | % | ASTM E424 |
UV Cut-off | 305.0 | nm | ASTM E424 |
Volume Resistivity | min. 5 x 10¹⁵ | Ohm cm | ASTM D257 |
Dielectric Strength | min. 25 | KV/mm | ASTM D149 |
Comparative Tracking Index | 600.0 | V | IEC 60112 |
Regulatory & Compliance
- Regulatory Information
PHOTOCAP 15585P is a UL listed product in category QIHE2 Photovoltaic Polymeric Materials. Each HB Fuller manufacturing plant maintains a separate UL file. Please refer to UL file numbers E10488, E335471 and E335472.
Safety & Health
- Safety Information
Avoid contact with skin and eyes. Product will irritate eyes if contact occurs. Skin irritation is possible on prolonged or repeated contact.
Packaging & Availability
- Regional Availability
Storage & Handling
- Storage Conditions
Clean and dry conditions below 40°C and 70% RH. For best performance, the product should be stored and used at 65°F – 85°F. Do not freeze.