Tuskbond HGL100 - 22L Canister

1 of 57 products in this brand
Tuskbond HGL100 - 22L Canister High Gloss Laminate Adhesive is ideal for bonding glossy decorative laminate surfaces to a variety of substances, due to its even pebble spray pattern designed to give 100% coating.

Product Type: Laminating Adhesive

Application Area: Laminates, Veneering

Compatible Substrates & Surfaces: Aluminum, Brick, Chipboard, Concrete, Metal, Plasterboard, Plywood, Steel

Application Method: Spray

Features: Easy To Apply, Fast Drying, Fast Grab, Glossy Surface Aspects, Good Bonding Strength, Heat Resistance

Technical Data Sheet
  • TypeDocument Name
View All Documents

Enhanced TDS

Identification & Functionality

Features & Benefits

Applications & Uses

Markets
Applications
Application Area
Application Method
Compatible Substrates & Surfaces
Guidelines for Use

Preparation:

  • Use in a well Ventilated Area.
  • Surfaces to be bonded should be clean, dry and dust free. If cleaning solvents are used, allow adequate time for drying and wipe surface with a clean cloth before applying adhesive.
  • Shake aerosol before use.
  • Once the hose and gun has been attached to the canister, open the valve fully. Check the connection points for leaks at this time.
  • On first use, the canister may initially take a few seconds to spray correctly. Spray initially onto on a scrap surface to ensure the spray pattern is correct for the application. The trigger restrictor on the gun can be used to set the spray to the required width.

Application:

  • Hold the aerosol at 70° to the surface, approximately 4-6 inches away and apply a uniform coat of adhesive to both substrates.
  • Move at a steady pace that provides an even coat of adhesive without allowing any material to puddle. Spray one surface vertically the other horizontally. On porous materials, a second coat of adhesive may be necessary
  • Allow the solvents to evaporate from the adhesive (2-3 minutes depending on ambient temperature). To know when the adhesive is ready to bond, it should not transfer to a gloved hand when touched and should feel dry. Bonding the substrates before the solvents have been allowed to evaporate can cause solvent entrapment resulting in
  • bond failures.
  • Bring the two substrates together and apply a uniform pressure over the work piece, starting in the middle and working outwards.
  • After use, invert the can and spray to clear any adhesive from the valve/button.

Properties

Physical Form
Appearance
Pale cream
Typical Properties
ValueUnitsTest Method / Conditions
Application Temperature15 - 25°C-
Temperature Resistant100.0°C-
Open Time60.0minutes-
Drying Time2 - 3minutes-
Cure Time24.0hours-
Coverage105.0-
Solids Content28.0%-
Storage Temperature15 - 35°C-

Packaging & Availability

Packaging Size

Available Sizes:

  • 22L Canister

Storage & Handling

Shelf Life
12 months
Disposal Information
  • Once the canister is empty of any hazardous materials and depressurised, it can be considered as scrap metal, in accordance with the national or local waste company, under code EWC 15 01 04* (empty aerosol, non-hazardous residues).
  • Canisters and aerosols that are still pressurised and contain product should be disposed of in accordance with the national or local waste company under code EWC 16 05 04* (full or partially empty aerosol).
Storage & Shelf Life
  • Protect from extremes of temperature in a controlled environment between 15 and 35°C, and away from direct sunlight. Do not stand on a cold concrete floor. Low temperatures can result in irreparable separation of the adhesive.
  • Stored under the correct conditions, in original, unopened containers, the product will have a shelf life of 12 months. The adhesive will have a limited life once the container is opened.