Enhanced TDS
Identification & Functionality
- Chemical Family
- RTU Product Type
- Technologies
- Product Families
Features & Benefits
- Labeling Claims
- Ready-to-Use Product Features
Applications & Uses
- Markets
- Applications
- Application Area
- Application Method
- Compatible Substrates & Surfaces
- Cure Method
Properties
- Physical Form
- Appearance
- Brown sprayable liquid
- Physical Properties of Cured Material
Value Units Test Method / Conditions Heat resistance 130 °C Internal HBF Standard - Physical Properties
Value Units Test Method / Conditions Density 0.82 g/cm³ - Solid Content 20 wt.% Internal HBF Standard Solid Content 20 wt% Internal HBF Standard - Cured Properties
Value Units Test Method / Conditions Heat resistance 130 °C Internal HBF Standard - Processing Parameters
Value Units Test Method / Conditions Processing Temperature 15 - 30 °C - Viscosity (at 20°C) 450 mPa·s Brookfield RVT Flash-off Time / Waiting Time 5 - 10 min - Consumption 250 - 300 g/m² - Required Spray Pressure 5 - 6 bar -
Technical Details & Test Data
- Processing Information
Processing
- Apply adhesive evenly with a suitable application method on the two parts to be bonded.
- After the recommended waiting time (flash-off time) put the parts accurately together and press.
- The waiting time depends on the ambient temperature, thickness of the adhesive film and absorbency of the surfaces.
- The surfaces to be bonded should be placed together when the adhesive film is still slightly sticky but does not stick to the finger when it is pressed lightly.
- The parts have to be bonded together within the Contact bonding time.
- Processing Information
Preparation
The surfaces to be bonded must be dry, clean, free of grease and free of dust to ensure a reliable bonding. Processing Apply adhesive evenly with a suitable application method on the two parts to be bonded. After the recommended waiting time (flash-off time) put the parts accurately together and press. The waiting time depends on the ambient temperature, thickness of the adhesive film and absorbency of the surfaces. The surfaces to be bonded should be placed together when the adhesive film is still slightly sticky but does not stick to the finger when it is pressed lightly. The parts have to be bonded together within the Contact bonding time.
Cleaning
Clean tools immediately after use.
Packaging & Availability
- Country Availability
- Regional Availability
Storage & Handling
- Storage Information
- Swift®col 2035 should be used within the shelf life specified on the packaging.
- The storage stability applies to material stored under appropriate conditions only (original unopened containers, recommended storage temperature). High temperatures shorten the shelf life. Low temperatures temporary cause a higher viscosity.