Millennium PG-1 SAF Pump Grade Adhesive

• Replaces fasteners - Minimizes deck corrosion and eliminates thermal bridging
• Essentially VOC free - Meets OTC and SCAQMD\
• Solvent free - Suitable for use with XPS and EPS insulation

• Millennium PG-1 SAF Pump Grade Adhesive is designed for use as an adhesive for bonding approved roof insulations to a building’s structural roof deck, base sheets, other insulation boards, and smooth or graveled built-up roof surfaces. It is dispensed 1/2” to 3/4” (1.3cm to 1.9cm) wide liquid beads that will quickly spread to a width 2-3 inches.
• Millennium PG-1 SAF Pump Grade Adhesive will expand and rise to fill minor surface irregularities.

1. Note: material must be approximately 70°F (22°C) for best application. Material stored and utilized at cold temperatures will be prone to crystallization of Part 1. Open the box utilizing the convenient tear strip and remove the plastic bladder from the box utilizing the easy-lift handle. Remove cap on plastic bladder and replace by attaching the quick connect fitting supplied in each box. (Connect the black fitting to the Part 1 bladder and the gray fitting to the Part 2 bladder.) Place the plastic bladder on the Patented Millennium Cyclone pump cart. Make sure that the bladder labeled “Part 1” is placed in the Cyclone tray labeled “Part 1” and that the bladder labeled “Part 2” is placed in the tray labeled “Part 2”.**
2. When using the Patented Millennium Cyclone low pressure pump cart, connect the black Part 1 fitting to the black feed hose fitting. Connect the gray Part 2 fitting to the gray feed hose fitting. Operate the pump according to Manufacturer’s instructions (see Cyclone Operator’s Manual).
3.  Utilize the empty cardboard container to capture adhesive pre- dispense or recycle empty cardboard containers.
4. Apply Millennium PG-1 SAF Pump Grade Adhesive directly to the substrate using a ribbon pattern. Space the beads 12” (30cm) on center to achieve proper coverage rates for standard insulation attachment. Note: proper bead placement will be determined by your OEM Roof System Manufacturer’s specifications.
5. Once Millennium PG-1 SAF Pump Grade Adhesive is applied, allow the foam to begin rising and place the insulation board into the adhesive before the adhesive has skinned over. Eliminate uneven surfaces to ensure positive contact between the insulation boards, adhesive and substrates.
6. Plastic bladders are designed for easy visibility to ensure adhesive maintains a 1:1 ratio. If material is not consumed at a 1:1 ratio stop application and check for blockage in hose or dispensing manifold.
7. Unused material can be applied at a later date. Properly clean and grease the dispensing wand and pump unit according to the manufacturer’s recommendations.
8. Millennium PG-1 SAF Pump Grade Adhesive provided in 15 or 50 gallon drum sets can be used with approved pump systems. The adhesives should be placed on a drum roller or agitated prior to use.

Replaces fastenersMillennium PG-1 SAF Pump Grade Adhesive is available in the following package:

Covers 600 sq ft (56m²) per case. Coverage estimates indicate total square feet of insulation/membrane attachment per case.