Enhanced TDS
Identification & Functionality
- RTU Product Type
- Plastics & Elastomers Functions
- Technologies
- Product Families
Features & Benefits
- Materials Features
- Ready-to-Use Product Features
Applications & Uses
- Markets
- Applications
- Application Method
- Compatible Polymers & Resins
- Compatible Substrates & Surfaces
- Cure Method
- Plastics & Elastomers End Uses
- Plastics & Elastomers Processing Methods
Properties
- Component A
Value Units Test Method / Conditions Density 0.84 g/cm³ DIN EN ISO 2811-1 Solid Content 12 wt.% Kö test method 100035 Storage Temperature 10 - 35 °C - Processing Temperature 15 - 25 °C - Viscosity 16 s Kö test method 100004 / DIN 4 - Physical Properties
Value Units Test Method / Conditions Density 0.85 g/cm³ DIN EN ISO 2811-1 Solid Content 11.5 wt.% Kö Test Method 100035 - Cured Properties
Value Units Test Method / Conditions Pot Life (depending on the ambient conditions) 12 - 24 - - - Processing Parameters
Value Units Test Method / Conditions Mixing Ratio (Comp. A : Comp. B) 10 : 1 - - Viscosity 15 s Kö Test Method 100004 / DIN 4 Wet Layer Thickness 100 - 140 µm - Dry Layer Thickness 10 - 15 µm - Flash Time (at 23°C) 15 m - Flash Time 5 m - Activation Temperature (with heat application at 40°C to 50°C) 60 - 90 °C -
Technical Details & Test Data
- Processing Information
Overmolding
After complete drying (refer to the flash-off time in the technical data table), the substrate can be overmolded immediately with the thermoplastic elastomer. Thermal activation of the primed substrate to the activation temperature (surface temperature) is advantageous. The time window between adhesion promoter application and overmolding depends on process and environmental conditions as well as the thermoplastic elastomer used and must therefore be carefully determined. Any surface contamination must be strictly avoided during the entire process. Suitability tests are recommended for new materials or material changes.Cleaning
Tools should be cleaned immediately after use. Once the product has cured, it can only be removed mechanically.
Packaging & Availability
- Regional Availability
Storage & Handling
- Storage Information
Köratac® GM 530 should be used within the shelf life indicated on the container. The stated shelf life (see product label) applies only to material stored under suitable conditions (unopened original containers, recommended storage temperature).