Thermonex® 090-05
1 of 6 products in this brandThermonex® 090-05 is a water-based, one-component adhesive known for its high heat resistance and low activation temperature. It is specifically designed for pre-application months prior to lamination. This adhesive offers the advantage of eliminating the need for onsite mixing of hardener, streamlining the factory floor process, and ensuring simplicity and consistency. Thermonex® 090-05 finds applications in press lamination and interiors.
Chemical Family: Isocyanates, Polyurethanes (PU)
Application Method: Roller, Spray
Compatible Substrates & Surfaces: Acrylonitrile Butadiene Styrene (ABS), Artificial Leather, Leather, Polycarbonate (PC), Polyvinyl Chloride (PVC) Film, Pre-treated Olefins, Textiles, Thermoplastic Polyolefin (TPO), Wood
Features: Good Bonding Strength, Heat Resistance, High Hydrolysis Resistance, Long Open Time
Enhanced TDS
Identification
- Chemical Family
- GBU
- RTU Product Type
- Categories
Applications
- Application Area
- Application Method
- Compatible Substrates & Surfaces
Features
- Ready-to-Use Product Features
Features & Benefits
- Labeling Claims
Packaging & Availability
- Country Availability
- Regional Availability
Properties
- Processing Parameters
-
Value Units Test Method / Conditions Activation Temperature min. 160 °F - Processing Temperature 60 - 80 °F - Storage Temperature 50 - 90 °F - Viscosity 10,000 - 15,000 mPa·s Internal HBF Standard PSA 3.1 - Physical Properties
-
Value Units Test Method / Conditions Solid Content 47 - 50 wt% Internal HBF Standard PSA 10
Storage & Handling
- Storage Information
-
- Thermonex® 090-05 should be used within the shelf life specified on the packaging.
- The storage stability applies to material stored under appropriate conditions only (original unopened containers, recommended storage temperature).
- Shelf Life
-
6 months
Technical Details & Test Data
- Processing Information
-
- Preparation
- The surfaces to be bonded must be dry, clean, free of grease, free of dust, free of oil and minimum surface tension 40 mN/m to ensure a reliable bonding. To ensure a reliable bonding a minimum surface tension of 40 mN/m is required.
- Processing
- For the bonding of genuine leather, artificial leather and spacer fabrics a double side adhesive application on the laminate and on the carrier is necessary to achieve the maximum bonding performance. For foil applications a single side adhesive application on the carrier is sufficient. Equipment, containers, hoses, etc. which come into contact with Thermonex® 090- 05 must be of corrosion resistant material (i.e. stainless steel 1.4541 or 1.4571 or plastic) to avoid coagulation. Any contact with non-ferrous metals (like hoses, sealing rings, filter bodies, etc.) must be avoided in any case. The adhesive can be applied by spraying out of a pressure pot or with automated mixing systems. The use of HVLP spray guns minimizes overspray. Also roller coating is possible as an application system. For more details please contact our technical service team.
- Drying
- The recommended maximum drying temperature can be found in the technical data section. Drying with dry air (< 10 % rel. humidity) leads to a faster and very gentle drying process. During the drying process, the humidity in the drying channel increases strongly. The excessive moisture content must be reduced either by fresh air supply or by drying out physically. Caution: The drying time is influenced by the absorbency of the surface, drying temperature, coating weight, air humidity etc. and needs to be checked under real life conditions.